Marvelous Designer Support

Objective

Set and modify the Zipper Slider, puller and Stopper properties.

※ Note: The Puller, Slider, and Stopper of the zipper have been separated so that each can be individually selected and edited. (Ver. 2025.0). 

 

Location

3D Toolbar ▶ Select/Move

Operation

• Select the tool indicated in Location.

• Select a Zipper or Stopper created on a 3D Garment and modify its properties:

  Option	Description
  Name	Customize the name of the zipper.
  Type (Ver. 2025.0)	One Way	One slider and puller is shown.
  	Two Way	Two sliders and pullers are shown which can be moved in opposite directions.
  Direction (Ver. 2025.0)	Direction can be configured when the type is set to Two Way.
  	Bottom to Bottom	Slider and Puller will be positioned near the Stopper, at the end of the zipper.
  	Head to Head	Slider and Puller will be positioned of the original position.
  Shape	Slider	Select a shape for the slider.
  	Puller	Select a shape for the puller.
  	Stopper	Select the Stopper type (Open / Closed End) and then select shapes for Top and Bottom. (ver MD10) ※ Note: A selection of Bottom shapes is configured based on the shape of the Stopper.
  Specification	Gauge	Select the size of the Slider by Gauge or percentage.
  	Weight (g)	Assign the weight of the slider. (Ver 4.2)
  Fasten Zipper	Reverse Zip Direction	Select the zip direction. The slider is relocated based on the option.
  	Move to Opposite Side	Select a side of the zipper tape where the slider will locate when the zipper is open.
  Material	Configure the Slider's Type, Texture, Color, and Opacity.  ※ Note: Uncheck Use Same Material as Slider after selecting the Puller or Stopper tab to assign material separately. (Ver. 10)
  Polygon Optimization (Ver. 2024.0)	Count	Set the number of polygons.
  	Plane	This is applied in the form of a texture when the Plane is activated. Count cannot be set on Plane activation.

   

※ Note: 

• Adjust the weight of the Slider