Objective
Modify the Zipper Slider and Stopper (ver MD10) properties.
Location
3D Toolbar ▶ Select/Move
Operation
-
Select the tool indicated in Location.
-
Select a Zipper or Stopper created on a 3D Garment and modify its properties:
Option
Description
Name
Name the zipper.
Shape
Slider
Select a shape for the slider.
Puller
Select a shape for the puller. Stopper
Select the Stopper type (Open / Closed End) and then select shapes for Top and Bottom. (ver MD10)
※ Note: A selection of Bottom shapes is configured based on the shape of the Stopper.Specification Gauge Select the size of the Slider by Gauge or percentage. Weight (g) Assign the weight of the slider. (ver 4.2) Fasten Zipper Reverse Zip Direction Select the zip direction. The slider is relocated based on the option. Move to Opposite Side Select a side of the zipper tape where the slider will locate when the zipper is open. Material Configure the Slider's Type, Texture, Color, and Opacity.
※ Note: Uncheck Use Same Material as Slider after selecting the Puller or Stopper tab to assign material separately. (ver MD10)
※ Note: Adjust the weight of the Slider
Polygon Optimization (ver. MD2024.0) |
Count | Set the number of polygons. |
Plane |
This is applied in the form of a texture when the Plane is activated. Count cannot be set on Plane activation. |
Article is closed for comments.